Single needle placement description

Needle placement description. Warning the needles are very sharp

Always have the tool pointing away from your body when inserting or removing the needle.

To insert needle

First support the holder in both hands with the slotted end away from your body. Use both thumbs to roll the “O ring” away and out of its groove towards the head of the tool, sliding the ring till it is loose on the body of the tool.

SCSFT_clip_image004Next, hold the needle by its head and slide the tip away from you under the loose ring, into the slot and through the inner ring. Then hold the needle where it protrudes from the tool and seat the needle head at the back of the slot, rotating the needle to secure it.

Lastly, slide the “O ring” back up the tool into its groove covering the needle head. For positive location the needle must remain rotated.

To remove needle.

Roll and slide “O ring” towards head of the tool as before, now apply light pressure to the needle towards the middle of the tool where the needle protrudes from the holder, this will lift the needle head from its groove allowing the needle to be withdrawn.

Maintenance

A Very light spray then wipe with CRC, WD40, or similar lubricant will protect and nourish the rubber “O rings” and assist in preventing corrosion of the needles

eShop

Felting Tools